AC Delco Heater Hose

This 5/8" ID heater hose with a 90 degree bend will allow you to eliminate the leaky steel heater hoses on the back of your engine. This one piece hose will connect directly to the heater core and stay tight to the firewall.​

Body Plugs

When doing a body lift kit, it may be necessary to drill your rear cargo floor to access the captive nuts. These plugs will allow you to cover the hole cleanly and provide access in the future

Power Steering Adapters

Use these fittings to convert your Isuzu steering box to AN fittings. Perfect for custom plumbing, engine swaps or hydraulic winch installs. M16X1.5 inverted flare to -6AN. Fitting is steel

Moog ES3369T

This is the inner tie rod end needed for the "Big Tie Rod Upgrade" on your Isuzu. You will need two per vehicle.

Moog ES3370T

This is the outer tie rod end needed for the "Big Tie Rod Upgrade" on your Isuzu. You will need two per vehicle.

Moog ES3201S

This is the tie rod sleeve needed for the "Big Tie Rod Upgrade" on your Isuzu. You will need two per vehicle. This is the shorter sleeve suitable for Amigo 1988-1994, 4WD pickup 1988-1995, Rodeo 1991-1995, Trooper 1987-1991

Moog ES3368S

This is the tie rod sleeve needed for the "Big Tie Rod Upgrade" on your Isuzu. You will need two per vehicle. This is the longer sleeve suitable for 1992 to 2002 Trooper and 1996 to 1997 Rodeo applications.

Earl's Performance 592054ERL

If you would like to remove your clutch damper then this fitting will get your M12X1.0mm Inverted Flare master cylinder converted to -4 AN. This will allow for a very large selections of hoses and fittings.

Earl's Performance 612104ERL

This 120 Degree hose end will work with the -4 adapter in your  clutch master cylinder to point the hose down and over to the clutch slave cylinder which will allow you to eliminate the stock clutch line and damper.

Earl's Performance 600341ERL

This Earl's Speed Seal hose end is compatible with the -4 hose listed. This Banjo fitting will bolt to your stock slave cylinder and allow you to eliminate your stock clutch line and damper.

Earl's Performance 600004ERL Hose

This Earl's Speed Seal PTFE hose is compatible with the -4 hose ends listed. Four feet should be ordered to complete the run from the master cylinder to slave cylinder.

Canton Racing Products 22-596

This Canton oil filter adapter will  fit the stock 18mm threaded nipple on your 2.8, 3.1L or 3.4L GM V6 oil filter pad. It will allow for remote mounting of the filter which will keep it away from the exhaust and allow for a much larger filter. Clearancing of the engine mount is required.

Canton Racing Products 22-620

This Canton oil filter mount will allow you to use a very common 13/16-16 Chevrolet style oil filter. These filters can be had at any parts store. The extra ports can be used to mount the stock oil pressure switch and sensor.

Wix 51060 Filter

This filter will fit the filter mount listed. It is the same as the filter used on millions of GM trucks.

Wix 51060 Filter

This filter will fit the filter mount listed. It is the same as the filter used on millions of GM trucks.